Replica revolver ASG Elite Force H8R 6 mm

Elite Force H8R gen 2 6 mm is a CO₂-powered ASG revolver, equipped with two accessory rails, 2 magazines, and fiber-optic sights. 

Modern style

Elite Force H8R gen 2 6 mm features a modern design inspired by contemporary revolver models. The frame, cylinder, and outer barrel are made of durable polymer coated with white powder paint.

Elite Force H8R gen 2 6 mm is equipped with two accessory rails in the 22 mm Picatinny standard, allowing the installation of a laser sight, flashlight, as well as a red dot or optical sight.

The modern design of the replica is emphasized by the high barrel profile with characteristic porting and an anatomically contoured grip with anti-slip texture.

The mechanical sights are enhanced with fiber inserts that make front and rear sight alignment easier and faster.

Trigger mechanism with safety lock

Elite Force H8R gen 2 6 mm features an SA/DA trigger mechanism, allowing precise shooting in single action mode (with the hammer cocked) or dynamic shooting using double action. In DA (double action) mode, the trigger pull is longer and requires more force.

Manually cocking the hammer in Single Action mode makes the trigger break (shot release) significantly faster and smoother.

CO₂ power supply

The revolver is equipped with an adjustable safety (located in front of the hammer), which, when engaged, blocks the trigger mechanism and eliminates the possibility of an accidental discharge during carrying or in the event of a fall.

Elite Force H8R gen 2 6 mm is powered by a 12 g CO₂ cartridge. One cartridge allows for approximately 60 shots with a muzzle velocity of about 100 m/s. Air temperature, shooting dynamics, and proper valve maintenance have the greatest impact on shot performance. It should also be remembered that a pierced CO₂ cartridge may remain in the replica for a maximum of 48 hours. After this time, the cartridge should be removed or discharged.

Installation and replacement of the cartridge are very simple, requiring only the removal of the grip panel, insertion of the cartridge into the grip, and tightening it with the pressure screw. This process is greatly facilitated by an Allen key permanently attached to the grip panel.

This simple solution ensures that the key is always at hand, helping to avoid an inconvenient situation where the cartridge cannot be replaced due to the lack of a tool.

The magazine function is performed by polymer inserts with a capacity of 10 BBs (2 magazines included). The loaded inserts are placed in the compartment in front of the cylinder.